Siemens SENTRON PAC RS485 - MODBUS Communication Parameter with the Function Codes 0 X03, 0 X04 and 0 X10; Table 5-21 Communication Parameters

Parameter assignment/Addressing
5.1 MODBUS RTU
PAC RS485
52 Manual, 02/2008, A5E02091800B-01
Offset Number
of
registers
Name Unit Format Value range from ... to Access
60009 1 Switching command for vector
group
- unsigned short High 0 ... 99, Low 0 ... 1
High byte group
assignment
Low byte 1 = ON,
0 = OFF
W
65300 1 Activation of a changed IP
configuration/ Ethernet
configuration
- unsigned short 0 W
1) The MODBUS master must acknowledge these diagnostics bits.
See also
Modbus measured variables with the function codes 0x03 and 0x04 (Page 33)
5.1.10 MODBUS communication parameter with the function codes 0x03, 0x04 and 0x10
Addressing the communication parameters
Table 5-21 Communication parameters
Offset Number of
registers
Name Unit Format Applicable
MODBUS
function codes
Value range
from ... to
Access
63001 2 IP address - unsigned long
• 0x03
• 0x04
• 0x10
0 ... FFFFFFFFh RW
63003 2 Subnet mask - unsigned long
• 0x03
• 0x04
• 0x10
0 ... FFFFFFFFh RW
63005 2 Gateway - unsigned long
• 0x03
• 0x04
• 0x10
0 ... FFFFFFFFh RW
63007 2 Bootloader version - unsigned long
• 0x03
• 0x04
char, uchar,
uchar, uchar
R
63009 2 Password protection
ON/OFF
- unsigned long
• 0x03
• 0x04
0, 1 R
0 = MODBUS
TCP
63015 2 Ethernet protocol - unsigned long
• 0x03
• 0x04
• 0x10
1 = SEAbus TC
P
RW
0 = MODBUS
RTU
63017 2 Protocol
1)
- unsigned long
• 0x03
• 0x04
• 0x10
1 = SEAbus
serial
RW