Siemens SENTRON Series User Manual

Expansion module I(N), I(Diff), analog
Manual, 04/2017, L1V30408520AG-01
15
Mounting
3
3.1 Warning
WARNING
Danger! High voltage
Using devices when they are damaged may result in death, serious injury, or property
damage!
Do not install or start up damaged devices.
3.2 Installation location
The expansion module is inserted in the slot labeled "MOD1" or "MOD2" on the rear panel of
the PAC3200 / PAC4200.
NOTICE
Sudden temperature fluctuations
Condensation can cause the device to malfunction.
Store the device in the operating room for at least two hours before commencing
installation.
3.3 Installation steps
Install the expansion module before staring up the SENTRON device.
NOTICE
Impairment and endangering of operation
Damaged components can impair and endanger operation.
Never put components into operation if they are damaged.

Siemens SENTRON Series Specifications

General

Product Series	SENTRON
Category	Measuring Instruments
Frequency Range	45-65Hz
Communication Interfaces	Modbus RTU, Ethernet
Display	LCD
Protection Class	IP20
Operating Temperature Range	-10°C to +55°C
Storage Temperature Range	-25°C to +70°C
Relative Humidity	5% to 95% (non-condensing)
Mounting	DIN rail