Siemens SENTRON Series - Setting the expansion module parameters

Commissioning
5.2 Setting the expansion module parameters
Expansion module I(N), I(Diff), analog
24 Manual, 04/2017, L1V30408520AG-01
5.2 Setting the expansion module parameters
The parameters for the expansion module can be set either directly on the PAC display or
via the communication interface of the PAC device using the SENTRON "powerconfig"
configuring software.
The SENTRON powerconfig configuring software can be downloaded from the Industry
Online Support website (https://support.industry.siemens.
com/cs/ww/de/view/63452759).
Setting parameters on the PAC device
In the menu "EXPANSION MODULES", call the "I(N) I(DIFF) ANALOG" that you want to
configure and then select menu item "SETTINGS".