Siemens SIMATIC C7-613 - Integration into the User Program

4-1
C7-613 Control System
A5E00138934-03
Integration into the User Program
4.1 Installing the CD
The configuration interface and the blocks needed for integrating the HMI functions
into your user program are on the CD “Configuration Tools for SIMATIC C7-613”.
During the installation process, the “C7 613 library” is set up where the blocks are
stored. To install the CD, proceed as follows:
Step Action Result
1 Before starting the setup, close all
applications
(for example, STEP 7, MS Word, etc.).
2 Place the CD in the CD drive of your
programming device/PC.
3 Start the “Setup” program in the Setup
folder.
4 Follow the step-by-step instructions
displayed by the installation program.
The following components are
installed on your computer:
• Configuration interface
• “C7-613” library with the required
FBs and UDTs
• Sample program
“ZXX31_01_C7-613”
• Manual
• Getting Started
4