Technical specications
7
Technical specications 6DL2804-xxDxx / xxExx
6DL2804- xxDxx xxExx
Degree of protection 6DL2804-****0 and 6DL2804-****2: IP65
6DL2804-****1: IP66
Dimensions: W x H x D 650 x 450 x 230 950 x 450 x 230
Material Stainless steel: DIN 1.4404, plate thickness 1.5 mm
Weight [kg] 30 43
Cover seal Silicone foam
Cable entries for
Voltage 2 M32 Ex e
Bus 4 M20 Ex e
Signals M16
3 rows (xxx3x) 39 66
5 rows (xxx5x) 65 110
Signals M20
3 rows (xxx4x) 36 57
5 rows (xxx6x) 60 95
Equipotential bonding rail 3 x 10 mm Cu
Bonding terminals 0.75 to 35 mm² Ex e for equipotential bonding cable, 4 mm²
for shield connection
Grounding conductor connection M6 screw, at least 16mm² with cable lug
Rated voltage/current
1)
These values depend on the installed components.
Ambient temperature range
6DL2804-1xxxx with installation of ET200iSP -20°C to +xx°C
2)
6DL2804-1xxxx with installation and heating -40°C to +xx°C
2) 3)
6DL2804-2xxxx
with installation of ET200iSP and electro-pneumatic system
AirLine Ex Typ 8650
0°C to +xx°C
2)
Permissible humidity Max. 95%
1)
The actual electrical values depend on the electrical equipment installed. The manufacturer species the nal values within
the framework of these limits.
2)
The specied permissible ambient temperature range is only applicable if the enclosure is installed horizontally. The max.
ambient temperature is dened depending on the power dissipation of the installed components, and specied on the
nameplate.
Note that the ambient temperature of the total conguration must be checked again if further components are subsequently
tted.
3)
The temperature range of -40°C is only possible when a heater is installed (see also section "Using the I/O device with
temperatures up to -40°C").
Distributed I/O device 6DL2804-1xxxx & 6DL2804-2xxxx
Hardware Installation Manual, 11/2023, A5E42025214-AC 29
To Next Page
Loading...
Need help?
General
