EasyManua.ls Logo

Siemens simatic hmi op27

Siemens simatic hmi op27
240 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15-1
OP27,
OP37 Equipment Manual
Release 05/99
OP37 in DOS Mode
The
OP37 is also designed for use in DOS mode. It can be used for dif
ferent
applications. The default settings apply to operation with a configuration
created in ProT
ool. The OP37 can be used for applications which run under
both DOS or W
indows. These applications might be:
programming software
a standard application or
a customized application.
In order that the OP37 can be used in DOS mode, a data medium, such as disk,
hard disk or PCMCIA hard disk must be available. Set one of these data media
as the boot medium in Setup. Also, connect a keyboard and possibly a mouse
as well. An MF2 keyboard can be connected to the front connector
. A PS2 con
-
nector is available at the rear of the OP37 for connecting a PS2 keyboard, and
there is another connector for connecting a PS2 mouse.
Use
Conditions
15
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Related product manuals