17-6
OP27,
OP37 Equipment Manual
Release 05/99
17.5 Labeling
Function Keys
The
function keys on the operator panel are labeled ex works as follows:
F1 to F20 and
K1 to K16.
A set of unlabeled strips is enclosed with the OP. This means that keys on the
OP can be labeled according to individual systems.
Proceed as follows to replace the labeling strips:
1.
Set the unit down with its front plate facing downwards.
!
Caution
Make sure that the OP is disconnected from the power supply
.
2.
Remove the screws indicated in Figure 17-3 as
1
.
Figure 17-3 Undo screws
3. Remove
the covers.
4.
Extract the labeling strips to be replaced.
5.
Insert the new strips
2
with the inscription facing downwards into the slits
on the front plate (see Figure 17-4).
Labeling
OP37
Function Keys
Replacing labeling
strips
OP37 Unit Description
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
