Operating a project
8.1 Operating a project on OP 73micro
OP 73micro, TP 177micro (WinCC flexible)
108 Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
Procedure – editing specific characters of a value
Proceed as follows:
1. Press
ENTER
.
2. Select the relevant character with
INS
or
DEL
.
3. Replace the character with
TAB
or
+/–
.
4. Press
ENTER
.
This confirms your entries. To cancel the entry, press
ESC
.
Call sequence of the characters
When you initially enter a value in an alphanumerical input field, the letter "A" is called by
pressing
ENTER
or
INS
. The same applies when you add characters.
The following applies for further entries:
● Press
TAB
to enter letters.
Upper and lower case letters are indicated first, followed by the special characters and
numbers.
To toggle between an upper and a lower case letter, press
SHIFT
.
● Press
+/–
to enter numbers.
The list opens with various special characters and continues with the numbers.
Press
+/–
or
TAB
to view the next value if you already entered a value.
Procedure – deleting a character
1. Press
ENTER
.
2. Position the cursor on the character to be deleted.
3. Press
SHIFT
+
DEL
.
The selected character will be deleted. The remaining characters to the right of the cursor
shift by one position to the left.
If the characters are right aligned:
The selected character will be deleted. The remaining characters to the left of the cursor
shift one position to the right.
To Next Page
Loading...
Need help?
General
