Configuring the operating system
6.2 Configuring the operating system for the TP 177micro
OP 73micro, TP 177micro (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DF01-0AB0
81
See also
Switching on power and testing the HMI device (Page 55)
6.2.2 Control Panel
6.2.2.1 Overview
Control Panel of the HMI device
The HMI device Control Panel can be used to modify the following HMI device settings:
● Screen settings
● Transfer settings
Opening the Control Panel
Open the Control Panel using the HMI device Loader.
The following options are available to open the Loader:
● The Loader appears briefly after starting the HMI device.
● During runtime:
If configured, touch the relevant operator control object to stop the project. The Loader is
displayed. Further information on this may be available in your plant documentation.
Touch the "Control Panel" button in the Loader to open the HMI device Control Panel.
Figure 6-15 HMI device Control Panel
"OP" Change screen settings, display information on HMI device, calibrate touch
screen
"Password" Set password protection for the Control Panel
"Screen Saver" Configuring the screen saver
"Transfer" Configure the data channel
To Next Page
Loading...
