Figure 4-5 Example: "Drive" screen, single-circuit
Further information can be found in the List Manual of the converter, Chapter "PROFIdrive",
Section STW1, ZSW1.
4.2.5 "Infeed" screen
The "Infeed" screen displays the current status of the control bits. The bit values are displayed
as follows:
● High signal = green
● Low signal = white
This screen shows faults in the communication between the converter and the infeed.
Calling the screen
Press the <Status> button in the navigation bar. Select the "Infeed 1" screen for a single circuit
or the "Infeed 2" screen for a double circuit.
Screens
4.2 "Status" screen selection
TP900 Function Manual
Function Manual, 10/2016, A5E39487277A 21
To Next Page
Loading...
