Siemens SIMATIC IM 151/CPU User Manual

*HWWLQJ6WDUWHG
Getting Started - ET 200S-IM 151/CPU Interface Module
A5E00058783-01
8-3
6WHS,QVWDOOLQJWKH(76,0 &38DQG6
6WDJH 'HVFULSWLRQ
1 Install the S7-300 as described in the S7-300 Programmable Controller, Hardware and
Installation
manual or in STEP 7 V5.0 Getting Started .
2 If you want to operate the IM 151/CPU with its own power supply, attach it to the S7-300 rail
and tip it down until it snaps into position.
3 Attach the IM 151/CPU to the rail, and tip it down until it snaps into position.
4 Attach the TM for the PM to the rail on the right of the IM 151/CPU, and tip it down until it
snaps into position.
5 Move the TM to the left until you can hear it engage with the IM 151/CPU.
6 Repeat steps 3 and 4 with the two TMs for the electronic modules and then with the
terminating module (which doesn‘t snap onto the rail).
7 Push the PM into the corresponding TM until it snaps into position.
8 Push the DI into the left (still unoccupied) TM until it snaps into position.
9 Push the DO into the last (still unoccupied) TM until it snaps into position.
Installing the ET 200S

Siemens SIMATIC IM 151/CPU Specifications

General

Brand	Siemens
Model	SIMATIC IM 151/CPU
Category	Control Unit
Language	English