Siemens SIMATIC IM 151/CPU

Configuration Frame and Parameter Assignment Frame for the ET 200S
A-7
ET 200S Interface Module IM 151/CPU
A5E00058783-01
Structure of the General Parameters for the IM 151/CPU
The length of the general parameters for the IM 151/CPU is 3 bytes.
The following parameters can be set:
Byte 7
Bit no.
0: different DP master
1: S7/M7 DP master
Byte 8
6
5
Byte 9
Watchdog timer 0: 10 ms (different DP master)
1: 1 ms (S7/M7 DP master)
00
0
000
0
0
Failsafe mode: set by STEP 7 , depends on the DP master
Bit no.
74320
7
2
7320
65
1
DPV1_Status_1
DPV1_Status_3
DPV1_Status_2
Bit no.
DataExchangeBroadcast
0: Check CFG mode STOP
1: Check CFG mode RUN, resulting in PRM-FAULT
Update interrupt enable
Status interrupt enable
Manufacturer interrupt enable
Diagnostic interrupt enable
Process interrupt enable
Module removal/insertion interrupt enable
Interrupt resources model
Value ignored, station always working in type mode (0)
0: Structured user PRM OFF (DDB standard)
1: Structured user PRM ON
0: PRM CMD OFF (DDB standard)
1: PRM CMD ON
Figure A-4 General Section of the Parameter Assignment Frame for the IM 151/CPU