Siemens SIMATIC IM 151/CPU

Configuration Frame and Parameter Assignment Frame for the ET 200S
A-5
ET 200S Interface Module IM 151/CPU
A5E00058783-01
Configuration Frame with the Default Setting for Address Areas
If you don’t parameterize the IM 151/CPU and therefore don’t specify any address
areas for data transfer with the DP master, the IM 151/CPU will start up after
commissioning with a default setting on the PROFIBUS-DP.
In the figure below you will find the configuration frame for the default setting:
 16 words of input data; unit consistency (i.e. word)
 16 words of output data; unit consistency (i.e. word)
Table A-4 Structure of the Configuration Frame with Default Setting for the Address Areas (Normal
Identifier Format in Accordance with AKF)
Configured
Address
Areas
Byte
1.
0000000
0
2.
0000000
0
3.
0000000
0
4. 70
Bit no.
6
4
5
312
Length of the input data: 16 words
Length specified in words
Consistency over words
Input data:
01101111
5.
70
Bit no.
6
4
5
312
Length of the output data: 16 words
Length specified in words
Consistency over words
Output data
01101111