Siemens SIMATIC IPC427D User Manual

Technical specifications
8.7 BIOS description
SIMATIC IPC427D
Operating Instructions, 05/2017, A5E31347215-AB
167
8.7.11
Alarm, error and system messages
During startup (the boot process), the BIOS first performs a
P
ower
O
n
S
elf
T
est (POST) and
checks whether certain functional units of the PC are operating error-free. The boot
sequence is immediately interrupted if critical errors occur.
BIOS initializes and tests further functional units if the POST does not return any errors. In
this startup phase, the graphics controller is initialized and any error messages are output to
the screen.
The error messages output by system BIOS are listed below. For information on error
messages output by the operating system or application programs, refer to the
corresponding manuals.
On-screen error messages
On-screen error message
Meaning / tip
Operating system not found Possible causes:
• No operating system installed
• Incorrect active boot partition
• Wrong boot drive settings in SETUP
Keyboard controller error Controller error.
Contact your technical support team.
SMART failure detected on HDD Hard disk reports pending failure through
S.M.A.R.T.
CMOS battery failed
CMOS battery is not connected.
CMOS battery weak
CMOS battery is weak
Real-time clock has lost power
The CMOS clock was operated without battery or
with a battery that was too weak, during battery
change, for example. Check the CMOS clock.
Keyboard error
No keyboard inserted.
PLD configuration failed Programming of the PLC on the motherboard
has failed.
8.7.12
Performing a BIOS update
Download of BIOS update
Check regularly if updates are available for download to your device.
You can find the downloads on the Internet at "After Sales Information System
(http://www.siemens.com/asis)". You can find drivers and BIOS updates to download with
your device or via the Search function.

Siemens SIMATIC IPC427D Specifications

General

Brand	Siemens
Model	SIMATIC IPC427D
Category	Industrial PC
Language	English