Device maintenance and repair
7.2 Repair information
SIMATIC IPC427D
82 Operating Instructions, 05/2017, A5E31347215-AB
These safety rules are based on the DIN VDE 0105 standard.
Note
These safety steps must always be taken in the above order before any work on electrical
systems. Once work on an electrical system is finished, cancel the
safety steps starting with
the last and finishing with the first.
In accordance with the applicable safety regulations, clearly indicate on an electrical system
that work on it is underway.
Observe the safety regulations applicable in the country of operation.
Electrostatic-sensitive components
The device contains electronic components which are destroyed by electrostatic charges.
This can result in malfunctions and damage to the machine or plant.
Make sure you take precautionary measures even when you open the device, for example,
when opening device doors, device covers or the housing cover. For more information,
refer to the chapter "ESD Guideline (Page 108)"
Risk of explosion and release of harmful substances
Improper handling of lithium batteries can result in an explosion of the batteries. Explosion
of the batteries and the released pollutants can cause severe physical injury.
Observe all safety and handling instructions for lithium batteries. Do not expose lithium
batteries to flames and do not solder the battery cell. Do not recharge, open, or short
lithium batteries. Do not reverse lithium battery polarity or heat the batteries to over 100°C.
Keep lithium batteries out of direct sunlight and protect them from moisture and
condensation.
To Next Page
Loading...
Need help?
General
