Maintaining and repairing the device
8.5 Installing the software
SIMATIC IPC477E PRO
Operating Instructions, 08/2017, A5E39912462-AA
99
Partitioning in Windows 7 Ultimate
You will need to reconfigure the partitions after installing a new drive, to repair corrupt
partitions or to change the partitioning.
Partitioning of the HDD or SSD
In delivery state, the following default partitions are set up on the HDD or SSD for the
Windows 7 Ultimate operating system:
Primary Boot 100 MB 100 MB 100 MB Automatically set up by installation
Third Data Remainder Remainder Remainder NTFS not compressed
Changing the partitions under Windows 7 and Windows 10
With the disk management, you can adapt the partitioning of your drives.
You can reduce or delete an available partition to acquire unassigned memory space, which
you can use to set up a new partition or to increase an existing partition.
Note
Data lost in the case of deleting a partition!
If you delete a partition, all the data on this partition is lost.
Back up your data before you change partitions.
You are logged on as an administrator.
Procedure - Reduce partition
A partition can only be reduced if sufficient space is available.
1. Click with the right mouse button on the partition to be reduced and click on "Reduce
size".
2. Follow the instructions.
To Next Page
Loading...
Need help?
General
