2
2-3
Working with S5-DOS/ST
C79000-G8576-C760-03
2.2 Installing the STEP 5 Basic Package
If you have purchased a new programming device from Siemens,
the system software together with STEP 5 is already installed on
the programming device in compressed form in five languages.
After you have set up your programming device and turned it on, a
menu is displayed in which you can select the language in which
you want to install the system software. The remaining steps of the
installation are also menu-driven.
The most important information about the retrofit package can be
found in the accompanying Product Information.
When ordering, please remember that there are different packages
for PGs and PCs.
The following conditions must be met if you want to install
STEP 5 on your PG or PC:
Hardware:
– Hard disk:
You require a hard disk partition with at least 10 Mbytes of
free memory.
– RAM:
You need at least 640 Kbytes
(1 Mbyte is recommended)
Operating system;
– MS-DOS 5.0 or 6.2
– Windows 3.1 or Windows for Workgroups 3.11
– Windows 95
Files with the same name are overwritten when you install the
newer version. The remaining STEP 5 data are retained.
Startup
Condition
Installing and Starting Up
To Next Page
Loading...
Need help?
General
