2
2-4
Working with S5-DOS/ST
C79000-G8576-C760-03
Installing the system software is described in detail in the Product
Information. Here, only the principle is explained.
1. Switch on your PG and go to the command level of MS-DOS.
2. Insert the first diskette of the retrofit package in drive A.
3. Call the installation program by typing:
A:INSTALL
For all subsequent steps, the program displays menus in which you
can make your selections.
Read the explanations which appear on the screen during the
installation and follow the instructions.
If you use the Windows 95 operating system, you can also install
STEP 5 from the Windows interface.
Proceed as follows:
1. Insert the installation diskette in drive A.
2. Open up My computer by double-clicking in the icon.
3. Select Floppy (A:).
4. Open drive A.
5. Start the installation procedure by double-clicking on the file
INSTALL.PIF (The file appears as an ”Install” with the icon
”Shortcut to an MS-DOS application”).
Windows 95 will install the programs and icons for STEP 5 in the
start menu under SIMATIC.
Installing STEP 5
under MS-DOS
Installing STEP 5
in Windows 95
Installing and Starting Up