2
2-11
Working with S5-DOS/ST
C79000-G8576-C760-03
Note
Selecting the EPROM driver in the window entitled “Loading
driver” (see page 2–14) will not affect the installation of the
external serial prommer.
When selecting the parallel LPT port, a selection for LPT 1, LPT 2
and LPT 3 are displayed in addition. The existing LPT port can be
specified here.
When selecting the serial port, a selection for COM 1, COM 2,
COM 3 and COM 4 are displayed in addition. The existing COM
port can be specified here.
2.4 STEP 5 Language Selection
If more than one language is installed, when you start STEP 5, you
are asked to select the language you want to work in. If you only
want to use one language version of STEP 5, you can deactivate all
the other installed languages via the submenu Language. Active
language versions are displayed when this menu is called. The next
time you start STEP 5, the language selection screen is no longer
displayed and the program goes straight to the main STEP 5 menu.
Installed but inactive language versions can be reactivated again by
calling the Language submenu in the S5DRV.EXE program.
The program for changing the language selection is started under
MS-DOS
:
Type in the command S5DRV.
From the Language submenu you can decide which language is to
be used to start STEP 5.
Procedure
Installing and Starting Up
To Next Page
Loading...
