2
2-10
Working with S5-DOS/ST
C79000-G8576-C760-03
The first page of S5DRV.EXE offers you the choice of language in
which you want to run the program (German, English, French,
Spanish, Italian). In the menus which follow you can load or
unload EPROM, H1 and L2 drivers.
In the submenu PROMMER the drivers can be adapted to match
the EPROM programming hardware facilities, and in the submenu
Language you can select which language you want for STEP 5/ST,
V 6.6. Help is provided in the menu bar on all menus except the
startup menu.
If you have selected one of the network drivers for H1 or L2, this
is loaded in the S5AUTOEX.BAT file when the PG (PC) is next
started. If the EPROM driver is selected, it is loaded when the
STEP 5 application is started.
The PG 7xx is supplied with the internal EPROM programming
interface already installed. With PCs, the files for the parallel
external Prommer are loaded when the STEP 5/ST for PC software
is installed for the first time.
The following steps are necessary to activate a parallel EPROM
programming interface, for example, or to activate a serial
interface on a PC:
Start the program S5DRV.EXE.
Select the submenu PROMMER.
In this menu you can select between:
an internal programming interface (only in PG 7xx
programming devices)
a parallel external Prommer on an LPT port
a serial external Prommer on a COM port (only on PCs)
How to Use the
Program
Executing the
Selections
Installing the
EPROM Driver
Installing and Starting Up
To Next Page
Loading...
Need help?
General
