6
6-18
Working with S5-DOS/ST
C79000-G8576-C760-03
You start the actual transfer by pressing F1 in the “Send mode” or
“Receive mode” menu.
By pressing F1 the transfer is started for files in the set path/user
area. Files in subdirectories (under MS-DOS/FlexOS) are not
transferred.
With the key combination ALT + F1 the transfer is started for
files in the set path (directory) and all files in any subdirectories.
This function is available from version V1.4 in FTARC.EXE (for
MS-DOS) and in FTARC.286 (for FlexOS). An older version may
not be used on either of the two computers.
With F8 you return to the main menu. If you press F8 during a
transfer process, the file being transferred is completed and then
the transfer is aborted with the error message “abort after current
transfer”.
A message is displayed in the status line at the bottom of the
screen after a transfer has been completed successfully or aborted.
“transfers completed (all OK)” No errors have occurred.
“transfers completed (not OK)” Errors have occurred (see ...).
Error messages are entered in the directory TEMP in the file
FTARC.ERR.
You can output these messages, for example, with:
TYPE FTARC.ERR.
Starting the
Transfer
Transferring a
Directory
(Function Key F1)
Transferring a
Directory and
Subdirectories
(ALT + F1)
Abort/Return to
Main Menu
(Function Key F8)
Errors and Error
Messages
File Transfer
To Next Page
Loading...
Need help?
General
