Glossary-3
Working with S5-DOS/ST
C79000-G8576-C760-03
The base memory is a part of the main memory. It is 640 Kbytes
for all programming devices. This size is entered in the SETUP
menu under the entry “Base Memory” and this entry is not
changed even if the memory is extended.
A diskette which includes a boot sector on track 0, enabling it to
load the operating system.
A loading operation which transfers the operating system to the
system memory.
Pressing and immediately releasing the left mouse button; this
selects objects or commands.
The COM 1 port is a serial V.24/modem interface. On the PG, this
is also an active TTY interface with a 20 mA current loop. This
interface is suitable for asynchronous data transmission. It can also
be used to connect printers or prommers with a serial interface.
The COM 2 port is a serial V.24 interface which can be used to
connect a mouse, a printer, or a prommer with a serial interface.
These are files which define the configuration after booting.
The configuration software brings the device configuration up to
date when EISA modules are installed. This is done either by
copying the configuration files supplied with the module or by
manual configuration using the configuration utility.
B
Base Memory
Boot Diskette
Booting
C
Click
COM 1 Port
COM 2 Port
Configuration Files
Configuration
Software
Glossary
To Next Page
Loading...
Need help?
General
