03/2013 3 Setting up functions
3.4 Fault services
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-115
Function Description Type
Control
monitors
Tree for selecting the control monitor to be
processed. It can be expanded to show the
triggers defined in it, which can be jumped to
directly.
TREE
Basic settings
Status Switches the currently active control monitors on
or off on the next synchronization.
DISPLAY
SELECTION
Note:
Does not change the activation state of each
monitor.
Common start
date
The common start date defines the point at
which the trigger will begin to execute the control
monitor. Each time trigger can be set so that it
responds to the start date. If a start time has not
been specified, all triggers respond with the
reaction identification to the common start time.
Specifying dates in the past is not permitted.
Dates that are no more than 2 years in the future
can be specified.
DISPLAY
SELECTION
New triggers
participation
Default setting for the function setting for
triggers: If an individual trigger setting has not
been made for participation at the start date, the
triggers will respond at the start date.
DISPLAY
SELECTION
Remaining memory and PLC performance index
Overview of the remaining memory of the
individual PLC blocks and overview of the PLC
performance index currently in use and
maximum PLC performance index:
• PLC trigger configurations
• PLC trace configurations
• PLC trace data
DISPLAY
Exchanging
addresses in
notifications
An address that is configured in one or more
notifications of a control monitor can be replaced
by another address from the organization's
address book.
ACTION
To Next Page
Loading...
