03/2013 3 Setting up functions
3.4 Fault services
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-129
Function Description Type
Alarms
Initiate
trigger for
the following
alarms
Enter the alarms to be initiated:
List of individual alarms separated by commas, or
alarm number ranges separated by "–".
DISPLAY
INPUT
(max. 200
characters;
any numerals
permissible)
, and – are
permissible
special
characters)
Exclusion list
Exclude the
following
alarms
Enters the alarms that must not result in
initiating: List of individual alarms separated by
commas or alarm number ranges separated by
"–".
INPUT
Conditions
Opens the submenu for entering a PLC
condition.
ACTION
Note
If an alarm occurs, an action is only initiated if the PLC condition described here
occurs at the same time. If an alarm is pending and the condition is met after this,
the action will not be initiated.
See also Section: Machine trigger on "PLC variable"
To Next Page
Loading...
