Siemens Simatic S7-300 - Page 211

03/2013 4 Organizational tasks
4.1 Maintenance
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
4-211
Function Special
function
Description Type
to select the maintenance jobs that shall
be contained in the selection result.
If the due status is set as filter, but no
status is selected, then the result list will
be empty.
Announced If a maintenance job is initiated by a
time trigger in the server rather than by
a current status event of the machine,
you can check whether the next
maintenance job has already reached
the preview time after the current one
has been closed.
The filter can also be used to select the
other statuses and precisely not this
"announced" one, in order that these
jobs do not appear in the selection list.
The due status can specifically be used
to select the maintenance jobs that shall
be contained in the selection result.
If the due status is set as filter, but no
status is selected, then the result list will
be empty.
SELECTION
DISPLAY
Due Irrespective of the activation - event-
controlled or time-controlled - of a
maintenance job, setting the filter to
"due" permits the jobs to be selected
that should now be done.
The filter can also be used to select the
other statuses and precisely not this
"due" one, in order that these jobs do
not appear in the selection list.
The due status can specifically be used
to select the maintenance jobs that shall
be contained in the selection result.
If the due status is set as filter, but no
status is selected, then the result list will
be empty.
SELECTION
DISPLAY
edited No matter how the maintenance jobs
were once initiated, only the completed
jobs can be selected.
The filter can also be used to select the
other statuses and precisely not this
one, in order that these jobs do not
appear in the selection list.
The due status can specifically be used
to select the maintenance jobs that shall
be contained in the selection result.
If the due status is set as filter, but no
status is selected, then the result list will
SELECTION
DISPLAY