6 Administration 03/2013
6.1 Management of the organization
© Siemens AG 2006-2013 All Rights Reserved
6-284 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
Function Description Type
Software
release
Adapting the server software version of the
machine
Notice:
It is only possible to upgrade to a higher
software version. The upgrade is performed
the next time the machine is booted after the
change. After that it is no longer possible to
undo the change!
DISPLAY
SELECTION
Remote access
Always
request
approval
If the machine requests remote access (this is
only possible from the machine), and the
location to be accessed connects to the
machine, access approval must be granted
again on the machine.
Where remote access is concerned, a
distinction is still drawn between the different
actions (visualization and operation; retrieving
data; saving data; NC operation; PLC access)
that must be acknowledged in a session as
having approval.
DISPLAY
SELECTION
Measurements
Display rigidity
Here you can define whether the rigidity is also
to be displayed for the axis test.
DISPLAY
SELECTION
Machine status
Client monitoring is activated automatically.
The variables that can record start and end of
the possible data acquisition are available.
DISPLAY
SELECTION
Activate
machine
status
recognition
Generate
machine event
The data acquisition start and end status
signals generate event entries.
DISPLAY
SELECTION
Archive event Machine events are generated for reading in
archives at the control.
DISPLAY
SELECTION
Automatic connection
Connect
machine
automatically
The client of the machine automatically
connects to the server as soon as a
connection is established.
DISPLAY
SELECTION
Connection
via
The following can be selected to detect a
connection:
• IP address
• MAC address
• Machine name (max. 50 characters)
DISPLAY
SELECTION
INPUT
Device class The device class defines the
SINUMERIK Integrate functions that can
always be used on a particular machine.
Various functions cannot be used depending
on the device class.
See also Section: Client diagnostics
SINUMERIK, S7, and IPC are available in the
selection.
DISPLAY
To Next Page
Loading...
