2 Machine information 03/2013
2.3 Test series on the machine
© Siemens AG 2006-2013 All Rights Reserved
2-62 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
The following prompt is displayed if a manual axis test is not performed after
changes in the prolog and epilog as well as of axis test-specific parameters:
Fig. 2-40: Permanently saving the prolog/epilog program
Message Meaning
"Do you want to accept the
changes and check with an axis
test?"
If the axis test has already been performed
successfully, it is marked as "Tested".
If you press the "Select" softkey, "Tested" is
reset and a one-time successful execution of
the axis test is required in order to be able to
also execute this automatically (e.g. via
maintenance schedules).
"Do you want to accept the
changes, but not check with an
axis test?"
If the axis test has already been performed
successfully, it is marked as 'Tested'.
If you press the "Select" softkey, "Tested" is
not reset and a new axis test is not required.
"Do you want to reject the
changes?"
Currently executed changes are rejected. If the
axis test has already been performed
successfully, it is marked as "Tested". If you
press the "Select" softkey, "Tested" is not reset
and a new axis test is not required.
Note
The option not to perform a manual axis test again in order to retain the 'Tested'
marking despite changes to data relevant for the axis test, must be enabled in the
organizational data.
To Next Page
Loading...
