Siemens Simatic S7-300 - Page 64

2 Machine information 03/2013
2.3 Test series on the machine
© Siemens AG 2006-2013 All Rights Reserved
2-64 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
Description of the call parameters
All position values refer to the machine coordinate system (MCS).
Equability test Circularity test Universal axis test
Return parameters, see below: Description of the return parameters
TRUE = Call as prolog
FALSE = Call as epilog
FRAME = Prolog/epilog of the test series
(The following parameters are irrelevant.)
EQUABILITY CIRCULARITY UNIVERSAL
Name of the measurement series (in UPPER CASE)
Channel axis number
of the traverse axis
Plane selection
(1 = G17, 2 = G18,
3 = G19)
Channel axis number
of the traverse axis
Channel axis number
of the measurement
axis
Reserved Reserved
Reserved Reserved Reserved
Reserved Reserved Reserved
Reserved Reserved Reserved
Reserved Reserved Reserved
Starting position 1st center point
coordinate of the
circle
Starting position
End position 2nd center point
coordinate of the
circle
Maximum position
Reserved Circle diameter Reserved
Feedrate Feedrate Reserved
Reserved Reserved Reserved
Reserved Reserved Reserved
Channel axis
(traverse axis)
Channel axis 1
(traverse axis)
Channel axis
(traverse axis)
Machine axis
(measurement axis)
Channel axis 2
(traverse axis)
Reserved
Machine axis
(traverse axis)
Reserved Reserved
Reserved Reserved Reserved
Reserved Reserved Reserved
Reserved Reserved Reserved