EasyManuals Logo

Siemens SIMOCODE pro Manual

Siemens SIMOCODE pro
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #112 background imageLoading...
Page #112 background image
Glossary
112
SIMOCODE pro - Fail-Safe Digital Modules
Manual, 11/2017, NEB631679702000/RS-AA/002
Safety Integrity Level (SIL)
Measure defined in IEC 61508, for the safety-related performance of an electrical or
electronic control device.
The IEC standard defines four SIL levels SIL1 to SIL 4, which are defined as the safety
implementations of electrical and electronic equipment. The SIL value describes the
specified safety function in the event of a fault.
SIL (Safety Integrity Level)
Measure defined in IEC 61508, for the safety-related performance of an electrical or
electronic control device.
The IEC standard defines four SIL levels SIL1 to SIL4, which are defined as the safety
implementations of electrical and electronic equipment. The SIL value describes the
specified safety function in the event of a fault.
SIMATIC
Name of products and systems for industrial automation from Siemens AG.
SIMATIC PDM
You can also configure SIMOCODE pro using the SIMATIC PDM (Process Device Manager)
software. The following options exist:
SIMATIC PDM as a standalone program
PDM integrated in STEP 7
SIMOCODE ES
Standard parameterization software for SIMOCODE pro, which can be run on a PC / PG
under Windows XP or Windows 7 Ultimate and Professional.
SIMOCODE pro S7 slave
The SIMOCODE pro S7 slave is a special slave with the following characteristics:
It supports the S7 model (diagnostic interrupts, process interrupts)
It can be parameterized
Slave
PROFIBUS DP is based on a master-slave architecture. Telegrams are sent by the master
to the addressed station (slave) and responded to by the slave.
Speed
Number of revolutions of a motor shaft.

Table of Contents

Other manuals for Siemens SIMOCODE pro

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOCODE pro and is the answer not in the manual?

Siemens SIMOCODE pro Specifications

General IconGeneral
Protection ClassIP20
Mounting TypeDIN rail mounting
Rated Operational Voltage24 V DC
Rated CurrentUp to 820 A
Protection FunctionsOverload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range-25°C to +60°C
Communication ProtocolsPROFIBUS DP, PROFINET, Modbus RTU
Analog OutputsUp to 2
Temperature MonitoringPTC/KTY, RTD (PT100/PT1000)
Digital OutputsRelay outputs, Solid-state outputs
Analog Inputs0/4-20mA, PT100/PT1000

Related product manuals