Siemens SIMOCODE pro

SIMOCODE pro - Fail-Safe Digital Modules
Manual, 11/2017, NEB631679702000/RS-AA/002
9
Introduction
1
1.1
Important information
Purpose of this manual
This manual helps you configure safety-related functions for machines and equipment with
the SIMOCODE pro V motor management system.
The safety-related functions are implemented with the two DM-F Local and DM-F PROFIsafe
fail-safe digital modules.
Required basic knowledge
To understand this manual, you will need to have a general knowledge of low-voltage
switchgear and controlgear, digital circuitry, automation technology and safety engineering.
Target group
This manual is written for people with the following qualifications:
● Qualification to start up and operate the SIMOCODE pro motor management system
● Qualification to start up and operate the modules of SIMOCODE pro Safety
Further information
Please note the information in the following operating instructions:
● DM-F Local fail-safe digital module
(https://support.automation.siemens.com/WW/view/en/49222263)
● DM-F PROFIsafe fail-safe digital module
(http://support.automation.siemens.com/WW/view/en/49222281)
● SIMOCODE pro basic unit
(https://support.industry.siemens.com/cs/ww/en/view/64151566)
You can find the operating instructions under the entry type "Manual"
(https://www.siemens.com/sirius/manuals)