Siemens SINAMICS G120P - Figure 3-8 Fitting CU to PM230 FSA to FSC

Installing/Mounting
3.3 Control Unit installation
Power Module PM230 IP55
32 Hardware Installation Manual, 2010-07-02, A5E02923635A AB
6. If an Operator Panel/Blanking Panel is to be fitted, ensure it is fitted once the top cover is
replaced.
7. Tighten the retaining screws on the PM top cover (tightening torque 1.5 Nm [13.3 lbf.in]).
Removing the CU
The CU is removed from the PM by using the CU release lever which is located to the right-
hand side of the internal fan. The lever is pushed towards the PM to release the CU (see
figure below).
2SHUDWRU3DQHO
7RSFRYHU
'W\SH
DGDSWHU
&RQWURO8QLW
3RZHU0RGXOH
&RQWURO8QLWUHOHDVHOHYHU
Figure 3-8 Fitting CU to PM230 FSA to FSC