Siemens SINAMICS G120P - Fitting the IOP and the Blanking Plate; Figure 3-10 Fitting CU to PM230 FSD to FSF

Installing/Mounting
3.4 Fitting the IOP and the blanking plate
Power Module PM230 IP55
34 Hardware Installation Manual, 2010-07-02, A5E02923635A AB
Removing the CU
The CU is removed from the PM by using the CU release mechanism which is located to the
right-hand side of the internal fan and just behind the top-rear of the CU.
The mechanism is pushed-down to release the CU.
2SHUDWRU3DQHO
'RRU
'W\SHDGDSWRU
&RQWURO8QLW
3RZHU0RGXOH
&RQWURO8QLWUHOHDVHPHFKDQLVP
Figure 3-10 Fitting CU to PM230 FSD to FSF
3.4 Fitting the IOP and the blanking plate
Overview
The Inverter has been designed to allow an Intelligent Operator Panel to be fitted to the front
of the inverter.
If an IOP is not to be fitted to the Inverter, then the supplied blanking plate must be fitted to
maintain the IP55/UL Type 12 rating.
The fitting of the IOP or blanking plate uses the same technique. To fit the IOP or blanking
plate to the Inverter the following procedure should be performed: