Siemens SINAMICS - Page 128

Parameterizing telegram (SetPrm)
The filter table is transferred, as dedicated block from the master to the slave with the
parameterizing telegram when a bus communication is established.
%ORFN/HQ

&RPPDQG
6ORW
6SHFLILHU
2IIVHW/LQN


2IIVHW/LQNQ



%ORFNKHDGHU
/LQN
/LQN
ದ
[(
[
[
[(
ದ
6SHFLILFDWLRQLQE\WHV
&DOFXODWHGIURP9HUVLRQ,'
7DS
9HUVLRQLGHQWLILHU
1XPEHURIOLQNV
3XEOLVKHU'3DGGUHVV
3XEOLVKHULQSXWOHQJWK
2IIVHWLQWKHSXEOLVKHUGDWD
7DUJHWRIIVHWLQWKHVXEVFULEHU
/HQJWKRIWKHGDWDDFFHVV
3XEOLVKHU'3DGGUHVV
7DS
)LOWHUWDEOH
+HDGHU
Figure A-10 Filter block in the parameterizing telegram (SetPrm)
Configuration telegram (ChkCfg)
Using the configuration telegram, a slave knows how many setpoints are to be received from
the master and how many actual values are to be sent to the master.
For slave-to-slave communication, a special space ID is required for each tap. The PROFIBUS
configuration tool (e.g. HW Config) generates this ID. The ID is then transferred with the ChkCfg
into the drive devices that operate as subscribers.
Commissioning PROFIBUS slave-to-slave communication
The commissioning of slave-to-slave communication between two SINAMICS drive devices
using the additional Drive ES package is described below in an example.
Communication
A.1 Communication
Industrial Security
128 Configuration Manual, 08/2017, A5E36912609A