Settings in HW Config
Based on the example of the project below, the settings in HW Config are described when
using standard telegrams.
Figure A-11 Example project of a PROFIBUS network in HW Config
Procedure
1. You have generated a project, e.g. with SIMATIC Manager and HW Config. In the project
example, you defined a CPU 314 controller as master and 2 SINAMICS Control Units as
slaves. Of the slaves, one CU310-2 DP is the publisher and one CU320-2 DP the subscriber.
2. Select the CU320-2 DP Control Unit as slave.
Communication
A.1 Communication
Industrial Security
Configuration Manual, 08/2017, A5E36912609A 129
To Next Page
Loading...
