9. Click the "Slave-to-slave communication overview" tab.
The configured slave-to-slave communication relationships are shown here which
correspond to the current status of the configuration in HW Config.
Figure A-16 Slave-to-slave communication - overview
After the slave-to-slave communication link has been created, instead of showing "Standard
telegram 2" for the drive object, "User-defined" appears in the configuration overview under
telegram selection.
Figure A-17 Telegram assignment for slave-to-slave communication
The details after creation of the slave-to-slave communication link for a drive object of the
drive device are as follows:
Communication
A.1 Communication
Industrial Security
Configuration Manual, 08/2017, A5E36912609A 133
To Next Page
Loading...
