Network Configurations
© Siemens AG 2002 All Rights Reserved 6NH7811-0AA22
MD2 Modem (07/2002) 5-51
5.3.1 Point-to-Point, 4-wire Full-duplex
Overview
Fig. 5-16 shows a configuration for a point-to-point, 4-wire full-duplex network.
Both MD2 modems represent 4-wire terminal points and are set to the "Normal with
DTR/RTS on" operating mode.
All available baud rates and character recognition methods except for "MID off" can
be used in this configuration.
The DIL switch settings on the MD2 modem and the switch settings on the LTOP2
are the same at both terminal points (see Table 5-35).
Fig. 5-16 Network configuration: point-to-point, 4-wire full-duplex
To Next Page
Loading...
