Siemens SINAUT ST7 - View of the MD2 Modem from above; Settings for the DIL Switches Accessible from above

Mounting and Installation
© Siemens AG 2002 All Rights Reserved 6NH7811-0AA22
MD2 Modem (07/2002)
2-9
2.1.6 View of the MD2 Modem from Above
The following illustration shows the MD2 modem viewed from above. It shows the
positions of the 5-pin and 10-pin DIL switches accessible from above.
Fig. 2-3 View of the MD2 modem from above
2.1.7 Settings for the DIL Switches Accessible from Above
The MD2 modem features a 5-pin and a 10-pin DIL switch (see Fig. 2-3). Both
switches are located directly on top of the housing grill. The 5-pin DIL switch is
used to specify settings for the dedicated line, the 10-pin DIL switch is used to set
the operating mode and the character recognition.
The DIL switches have the following individual functions:
· 5-pin DIL switch
- Send level –6 dB or 0 dB
- 2-wire or 4-wire mode
- One channel or two channel for 2-wire mode
- Baud rate 1200, 2400, 9600 or 19200
1
2
3
4
5
6
7
8
9
1
0
12345
Front door with 'Modem' inscription
5-pin + 10-pin DIL switches for
setting the desired functions of the
MD2 dedicated line modem
Settings: see section 2.1.7.