Siemens SINAUT ST7 - 4 Operating Modes and Character Recognition

To Next Page

To Previous Page

MD2 Modem (07/2002)

4-1

Operating Modes and Character Recognition

4.1 MD2 Operating Modes .........................................................................4-3

4.1.1 "Normal" Operating Mode ....................................................................4-5

4.1.2 "Normal" with DTR/RTS on" Operating Mode ......................................4-5

4.1.3 "Repeater" Operating Mode .................................................................4-6

4.1.4 "With RS485 Interface" Operating Mode..............................................4-7

4.1.5 "Signal refresh off" Operating Mode.....................................................4-8

4.1.6 Test Operating Modes..........................................................................4-9

4.2 Character Recognition of the MD2 .......................................................4-23

4.2.1 Character Recognition "Asynchronous 11 Bit" .....................................4-24

4.2.2 Character Recognition "Asynchronous 10 Bit" .....................................4-24

4.2.3 "MID on" Character Recognition ..........................................................4-25

4.2.4 "MID off" Character Recognition ..........................................................4-26

Other manuals for Siemens SINAUT ST7