Instructions for Operation with SINAUT ST1
© Siemens AG 2002 All Rights Reserved 6NH7811-0AA22
MD2 Modem (07/2002) 3-3
3.2 Connecting the MD2 to a TIM11 and TIM011B
Standard Cable
Cable 6NH7700-2AR60 is delivered with the MD2 modem (see following table).
This enables the MD2 modem to be connected with an LTOP overvoltage
protection module.
Table 3-2 Standard cable for the RJ12 port of the MD2 modem
Order no. Description Diagram
6NH7700-2AR60 Cable with 2 x RJ12 plugs for connecting the MD2
modem (RJ12) to a LTOP overvoltage protection
module (RJ12).
Cable length 6 m
There are two standard cables for connecting the MD2 to the SINAUT ST1
modules TIM11 and TIM011B (see following table). These are not included with the
MD2; both must be ordered separately.
Table 3-3 Standard cables for the SINAUT ST1 modules TIM11 and TIM011B
Order no. Description Diagram
6NH1701-7AN Cable for connecting the MD2 modem (RS232)
with a TIM11 (RS232) or an other terminal
(DTE) with an identically configured 25-pin
RS232 interface (socket) and slide lock.
Cable length 2.5 m
6NH1701-7BK Cable for connecting the MD2 modem (RS232)
with a TIM011B (RS232) or an other terminal
(DTE) with an identically configured 25-pin
RS232 interface (socket) and screw lock.
Cable length 1.0 m
The section 'Standard Cables for the RS232 Port' in Chapter 2 provides a
description of this cable's configuration.
MD2
To Next Page
Loading...
