; Select B.MPF on NCU2 in channel 2.
SELECT B.MPF ch=NCU2,2
Sequence:
1. If a distributed job list is active during the selection, all distributed programs on the NCU
are deleted without confirmation. If the workpiece on the NCUs is empty, it will be deleted
there.
2. The programs are copied to the corresponding workpieces of the relevant NCU.
3. Existing programs are overwritten without any message.
4. Following a change in a distributed program on the local drive, the modified programs using
the Editor are copied to the corresponding NCU.
Sample structure
/user/sinumerik/data/ prog/
JOBA.WPD
NCU1 NCU2
JOBA.JOB WKS.DIR WKS.DIR
A.MPF WKS.DIR/JOBA.WPD WKS.DIR/JOBA.WPD
B.MPF WKS.DIR/JOBA.WPD/B.MPF WKS.DIR/JOBA.WPD/B.MPF
UP1.SPF JOBA.WPD/UP1.SPF JOBA.WPD/UP1.SPF
UP2.SPF WKS.DIR/JOBA.WPD/UP2.SPF WKS.DIR/JOBA.WPD/UP2.SPF
/user/sinumerik/data/ prog/
wks.dir/JOBA.WPD
NCU1 NCU2
JOBA.JOB WKS.DIR WKS.DIR
A.MPF WKS.DIR/JOBA.WPD WKS.DIR/JOBA.WPD
B.MPF WKS.DIR/JOBA.WPD/B.MPF WKS.DIR/JOBA.WPD/B.MPF
UP1.SPF JOBA.WPD/UP1.SPF JOBA.WPD/UP1.SPF
UP2.SPF WKS.DIR/JOBA.WPD/UP2.SPF WKS.DIR/JOBA.WPD/UP2.SPF
Supplementary conditions
Special behavior:
● Distributed programs are retained during a restart of the operating software.
● On the local drive, distributed programs can neither be deleted nor renamed nor overwritten
using copy/move.
● Changes of distributed programs on the NCU are lost, if they are not manually saved.
● The program correction in the machine is not offered.
● When creating a commissioning archive, all data of the local drive is also automatically
saved.
Channel menu
6.7 Distribution via job lists in the case of 1:N
SINUMERIK Operate (IM9)
92 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
