PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
77
Install software and updates
Installing SINUMERIK products
Overview
This chapter describes how to install additional software on the basis of the pre-installed
PCE basic software or how to carry out an update.
The description below is based on the delivery condition of the hardware and software
components.
The service desktop is, for example, used for the following tasks:
● Installing HMI system software
● Setting the running environment of the HMI system software
● Checking the hard disk or version
● Privilege for SIMATIC STEP 7
To Next Page
Loading...
Need help?
General
