Siemens SINUMERIK 804D sl Commissioning Manual

Table of contents
1 System settings............................................................................................................................................5
1.1 Delivery condition of the system..............................................................................................5
1.2 Meaning of switch positions.....................................................................................................8
1.3 System booting........................................................................................................................9
1.4 Displays during system booting.............................................................................................10
2 Configuring the system...............................................................................................................................13
2.1 Ethernet interfaces of the NCU..............................................................................................13
2.2 How to determine the IP address of the NCU........................................................................14
2.3 Configuration file "basesys.ini"...............................................................................................15
2.3.1 Section [ExternalInterface].....................................................................................................16
2.3.2 Section [InternalInterface]......................................................................................................18
2.3.3 Section [IBNInterface]............................................................................................................21
2.3.4 Section [SNMP]......................................................................................................................22
2.3.5 Section [DCP].........................................................................................................................24
2.3.6 Section [LLDP]......................................................................................................................24
2.3.7 Section [LinuxBase]...............................................................................................................25
2.3.8 Example: Configuration file 'basesys.ini'................................................................................30
2.4 Service Commands................................................................................................................38
2.4.1 Using service commands.......................................................................................................38
2.4.2 Syntax for the Actions............................................................................................................39
2.4.3 Generic elements...................................................................................................................40
2.5 Description of the actions.......................................................................................................42
2.5.1 Help........................................................................................................................................42
2.5.2 Check-cf.................................................................................................................................43
2.5.3 Clear.......................................................................................................................................43
2.5.4 Closeport................................................................................................................................44
2.5.5 Connect..................................................................................................................................44
2.5.6 Disable...................................................................................................................................47
2.5.7 Disconnect.............................................................................................................................48
2.5.8 Distribute................................................................................................................................48
2.5.9 Enable....................................................................................................................................49
2.5.10 ntpdiag (diagnostics)..............................................................................................................50
2.5.11 Openport................................................................................................................................51
2.5.12 Portstatus...............................................................................................................................52
2.5.13 Restart....................................................................................................................................52
2.5.14 Restore...................................................................................................................................53
2.5.15 Save.......................................................................................................................................54
2.5.16 save-nvram (data backup).....................................................................................................55
2.5.17 set-svc-route (gateway)..........................................................................................................56
2.5.18 Show......................................................................................................................................56
2.5.19 Start, Stop..............................................................................................................................60
NCU operating system
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 3

Siemens SINUMERIK 804D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 804D sl
Category	Control Systems
Language	English