Backing up and restoring data
4.4 Network settings in the Service Center
PCU-Basesoftware (IM8)
92 Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
You can make the following routing settings in the "Network Settings" dialog box:
Figure 4-3 Service Center - IP routing
Table 4- 3 Routing settings in the "Network Settings" dialog box
Specify the network destination of the route as an IP address.
Subnet mask of the specified IP addresses.
Next hop or forwarding IP address via which the network destination can be accessed.
Interface Select an interface to which the configured IP routing applies:
• Enterprise network interface X1 (Local Area Connection 2)
• Plant network interface X2 (Local Area Connection)
Metric Integer cost metric (1 to 9999). Required if several routes for sending a packet to a network destination are possible in
Release directory of the PC/PC in the network (Page 114)
Creating a shortcut to the network drive (Page 119)
Configuring routing in the network (Page 109)
To Next Page
Loading...
Need help?
General
