Procedure
Proceed as follows to configure the SITOP software for use with the PCU base software:
1. Call the settings of the SITOP software, for example, by right-clicking the SITOP UPS icon
in the Windows information area and then selecting "Configuration".
The "SITOP DC UPS Configuration" dialog box opens.
2. In the "General" tab, select "UPS" in the drop-down list at "Serial interface".
Configuration of the system
4.15 Configuring the SITOP UPS module for use with the PCU Base Software
PCU Base Software (IM10)
56 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
