Parameters Assignment
Spindle/gripper/loader for
magazine
● Tool spindle location 1 for magazine (separation 0)
● Gripper location 2 for magazine (separation 0)
● Gripper location 3 for magazine (separation 0)
● Transfer location 4 for magazine (separation 0)
Gripper/loader for spindle
● Tool spindle location 1 for gripper 2
● Tool spindle location 1 for gripper 3
Loading point for magazine
● Loading point location 1 for magazine (separation 0)
● Loading point location 2 for magazine (separation 3)
Tool management
12.6 Editor for the tool and magazine management
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 253
To Next Page
Loading...
Need help?
General
