_M71: ; Alignment tool: Swivel rotary axis
_AX1=$PC_TRAFO_ROT_CHAN_AX_IN[1] ; Rotary axis B
_AX2=$PC_TRAFO_ROT_CHAN_AX_IN[2] ; Tool spindle
IF(_TC_N_WZ==0) ; No tooltip tracking
N800710 TRAFOOF
ENDIF
SBLON
N800711 G0 G40 G60 G90 AX[_AX1]=_A1 AX[_AX2]=_A2
SBLOF
GOTOF _MEND
_M72: ; Alignment tool: End
GOTOF _MEND
_M75: ; Alignment tool: Deselection
N800750 G17 ; Standard plane for milling
N800751 SETMS(1) ; Sets tool spindle as main spindle
N800752 DIAMOF ; No transverse axis defined as diameter
programming for milling
GOTOF _MEND
Technologies and cycles
21.8 Turning on milling machines
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1 609
To Next Page
Loading...
Need help?
General
