Detailed Description
2.3 Continuous-path mode
Continuous-Path Mode, Exact Stop, LookAhead (B1)
2-34 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
The dynamic response for these axis movements is still derived from the machine data of the
DYNNORM default setting.
Technology G group
Five dynamic response settings are available in G code group 59 technology:
• DYNORM for standard dynamic response
• DYNPOS for positioning mode, tapping
• DYNROUGH for roughing
• DYNSEMIFIN for finishing
• DYNFINISH for smooth-finishing
For further information about programming, please refer to
References:
/PG/, Programming Guide Fundamentals, Path traversing behavior.
Enabling selected dynamics groups only
Some G codes can be deactivated by the machine manufacturer. If deactivated G codes are
programmed alarm 14011 is output. G codes DYNPOS for positioning mode and
DYNSEMIFIN for finishing, for example, can be deactivated with the following setting.
MD10712: NC_USER_CODE_CONF_NAME_TAB[0]="DYNPOS"
MD10712: NC_USER_CODE_CONF_NAME_TAB[1]=" "
MD10712: NC_USER_CODE_CONF_NAME_TAB[2]="DYNSEMIFIN"
MD10712: NC_USER_CODE_CONF_NAME_TAB[3]=" "
Configuring the dynamic response values.
The values for each technology group are stored in the following machine data:
• Axis
MD32300: MAX_AX_ACCEL[n]
MD32431: MAX_AX_JERK[n]
MD20600: MAX_PATH_JERK[n]
MD32432: PATH_TRANS_JERK_LIM[n]
MD32310: MAX_ACCEL_OVL_FACTOR[n]
MD32433: SOFT_ACCEL_FACTOR[n]
• Path
MD20602: CURV_EFFECT_ON_PATH_ACCEL[n]
MD20603: CURV_EFFECT_ON_PATH_JERK[n]
To Next Page
Loading...
Need help?
General
