Detailed Description
2.5 Block search
Mode Group, Channel, Program Operation, Reset Response (K1)
2-34 Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Type 4 block search with calculation at block end point
Example with automatic tool change after block search with active tool management:
1. Set machine data:
MD11450 $MN_ SEARCH_RUN_MODE to 1
MD11602 $MN_ASUP_START_MASK Bit 0 = 1 (ASUB Start from stopped state)
2. Select ASUB "BLOCK_SEARCH_END" from PLC via FB4.
References:
/FB1/ Description of Functions, Basic Machines: Basic PLC Program (P3)
3. Load and select part program "WORKPIECE_1".
4. Search to block end point, block number N220.
5. MMC signals "Search target found".
6. NC Start for output of action blocks.
7. With PLC signal:
DB21... DB32.6 (last action block active)
the PLC starts ASUB "BLOCK_SEARCH_END" via FC9.
References:
/FB1/ Description of Functions, Basic Machines: Basic PLC Program (P3)
8. After the end of the ASUB (can be evaluated, e.g., via M function M90 to be defined, see
example for block N1110), the PLC sets signal
DB21, ... DBX1.6 (PLC action complete).
Alternatively, VDI interface signal:
DB21-DB30 DBB318 Bit 0 (ASUP is stopped)
can be scanned.
As a result, Alarm 10208 is displayed, i.e., other actions can now be performed by the
operator.
9. Manual operator actions (JOG, JOGREPOS, overstoring)
10. Continue part program with NC Start.
To Next Page
Loading...
Need help?
General
