Transformations
7.8 Kinematic transformation
Job planning
7-60 Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
The velocity control makes allowance for the limits defined for the rotations.
E]Z
E]Z
<0
$60
;0
=
=0
<&0
Groove traversing-section
In the case of axis configuration 1, longitudinal grooves along the rotary axis are subject to
parallel limits only if the groove width corresponds exactly to the tool radius.
Grooves in parallel to the periphery (transverse grooves) are not parallel at the beginning
and end.
75$)2B7<3(BQ
75$)2B7<3(BQ
SDUDOOHOOLPLWHGORQJLWXGL
QDOVORWZLWKVORWZDOO
FRPSHQVDWLRQ
ZLWKRXWJURRYHZDOORIIVHW
7UDQVYHUVHJURRYH
/RQJLWXGLQDOVORW
To Next Page
Loading...
Need help?
General
