Tables
15.1 List of statements
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
15-21
ISNUMBER
Check whether the input string
can be converted to a number
BOOL Convert input
string to number
ISPOINTS Possible intersections
calculated by ISTAB between
two contours on the current
plane.
INT MODE machining
type (optional)
STATE=ISPOINTS
(KTAB1[n1], KTAB2[n2],
ISTAB, [MODE])
ISVAR Check whether the transfer
parameter contains a variable
known in the NC
BOOL Machine data,
setting data and
variables as
GUDs
J
4
Interpolation parameters Real s
J1 Intermediate point coordinate Real s
JERKA Activate acceleration response set via
machine data for programmed axes
K
4
Interpolation parameters Real s
K1 Intermediate point coordinate Real s
KONT Travel round contour on tool offset m 17
KONTC Approach/traverse with continuous-
curvature polynomial
m 17
KONTT Approach/traverse with continuous-tangent
polynomial
m 17
L Subroutine number Integer, up
to 7 places
L10 s
LEAD
5
Lead angle Real m
LEADOF Master value coupling OFF (lead off)
LEADON Master value coupling ON (lead on)
LFOF
1
Interrupt thread cutting OFF m 41
LFON Interrupt thread cutting ON m 41
LFTXT
1
Tangential tool direction on retraction m 46
LFWP Non-tangential tool direction on retraction m 46
LFPOS Axial retraction to a position m 46
LIFTFAST Rapid lift before interrupt routine call
LIMS Spindle speed limitation (Limit
Spindle Speed) with
G96/G961 and G97
0.001, ...,
99 999.
999
m
LN Natural logarithm Real
LOCK Disable synchronized action with ID
(stop technology cycle)
LOG (Common) logarithm Real
To Next Page
Loading...
